Project 2: part 1

Considering I'm in Wheel 1 and have never thrown a tea pot before, I don't think I did too bad.

 My idea started with some sketches of a tea pot and turned into this. I thought about doing a 2 piece mold to make the actual paper casting a 3D casting, but decided against it. I ended up cutting this pot in half with a wire tool and casting just half a tea pot. I was worried about the undercuts from the sides and handle, but the casting turned out surprisingly well.
My idea for the projection of video was to show water boiling inside the pot and then the steam coming out using stop motion animation. At first I thought I'd use watercolors to achieve this look, but thank God I didn't do that because that would've been soooo hard, haha. I ended up using different fabrics.